Installation guides

HP Victus 16 (2023) RAM & SSD Upgrade Guide (2026)

The HP Victus 16 (2023) (2023) is upgradeable with DDR5-4800 SODIMM RAM and supports up to 32GB across 2 slots. This guide covers RAM and SSD upgrade options.


HP Victus 16 (2023) Specifications

Portable external SSD storage drive
Portable external SSD storage drive
SpecificationDetails
Processor13th Gen Intel / Ryzen 7000
Release Year2023
RAM TypeDDR5-4800
RAM Slots2
Maximum RAM32GB
StorageM.2 2280 NVMe PCIe 4.0

HP Victus 16 (2023) RAM Upgrade Guide

Compatible RAM

The HP Victus 16 (2023) uses DDR5-4800 SODIMM modules. With 2 slots, you can install up to 32GB of RAM.

Recommended Configurations

ConfigurationTotal RAMModules
Budget16GB2 × 8GB SODIMM
Standard32GB2 × 16GB SODIMM

Installation Steps

  1. Shut down the laptop and disconnect the charger
  2. Remove the bottom panel screws (refer to your service manual for screw locations)
  3. Carefully pry off the bottom panel using a plastic spudger
  4. Disconnect the battery connector from the motherboard for safety
  5. Locate the RAM slot(s) — they are typically covered by a metal shield or near the centre of the board
  6. To remove existing RAM: push the retention clips outward and the module will pop up at an angle
  7. Insert the new SODIMM at a 30-degree angle, aligning the notch with the slot key
  8. Press down until the retention clips click into place
  9. Reconnect the battery, replace the bottom panel, and power on
  10. Verify in Task Manager (Ctrl+Shift+Esc → Performance → Memory) that the new RAM is detected

HP Victus 16 (2023) SSD Upgrade

The HP Victus 16 (2023) supports M.2 2280 NVMe PCIe 4.0 solid state drives. Upgrading the SSD is one of the best performance improvements you can make, especially if the laptop came with a smaller capacity drive.

SSD Installation

  1. Shut down and remove the bottom panel as described above
  2. Locate the M.2 SSD slot (usually secured with a single screw)
  3. Remove the retaining screw and carefully slide the existing SSD out at an angle
  4. Insert the new M.2 NVMe SSD at a 30-degree angle
  5. Press down flat and secure with the retaining screw
  6. Reassemble the laptop and install your operating system

Recommended Upgrade Products

ProductTypeBest ForLink
Crucial 16GB DDR5-4800 SODIMMRAM16GB stickShop
Kingston Fury Impact 16GB DDR5-4800 SODIMMRAM16GB stickShop
Corsair Vengeance 32GB DDR5-4800 SODIMM KitRAM32GB kitShop
Samsung 970 EVO Plus 1TB NVMeSSDHigh performanceShop
WD Blue SN570 1TB NVMeSSDGreat valueShop
Crucial P3 Plus 1TB NVMeSSDBudget NVMeShop

Prices and availability may vary. As an Amazon Associate, we earn from qualifying purchases.


Frequently Asked Questions

Q: What is the maximum RAM for the HP Victus 16 (2023)?

A: The HP Victus 16 (2023) supports up to 32GB of DDR5-4800 RAM across 2 SODIMM slots.

Q: Can I upgrade the RAM in the HP Victus 16 (2023)?

A: Yes, the HP Victus 16 (2023) has 2 accessible SODIMM slots. You can upgrade by removing the bottom panel and inserting compatible DDR5-4800 modules.

Q: What SSD does the HP Victus 16 (2023) use?

A: The HP Victus 16 (2023) uses a M.2 2280 NVMe PCIe 4.0 solid state drive. You can replace it with any compatible M.2 drive for more storage.

Q: How do I check my current RAM and storage?

A: Open Task Manager (Ctrl+Shift+Esc), click Performance, then check Memory and Disk tabs. For detailed specs, use CPU-Z (free utility).

Q: Is the HP Victus 16 (2023) worth upgrading?

A: Adding more RAM and a larger SSD can significantly extend the useful life of the HP Victus 16 (2023). A RAM upgrade improves multitasking, while an SSD upgrade provides more storage and faster boot times.


Related Guides


Leave a Comment

Your email address will not be published. Required fields are marked *